英语翻译Heavy duty hydraulic jacks where inside cylinder diameter is 300mm ,stroke 1.2 meters and shaft diameter 200mm and face mounting - just like in your press.cylinder thickness should be more than 25mm and should stand pressure 4000 psi.I ne

来源:学生作业帮助网 编辑:作业帮 时间:2024/12/01 11:21:39
英语翻译Heavy duty hydraulic jacks where inside cylinder diameter is 300mm ,stroke 1.2 meters and shaft diameter 200mm and face mounting - just like in your press.cylinder thickness should be more than 25mm and should stand pressure 4000 psi.I ne
xV@_e ">I1"@h(OX擯]U_/7DsxCkا'EEEl̐3I5袉%CAf1EIU)rJjp8Bi&BHbLq$eq9,UBƴPR]dPV(m(jtQ3g7+!khr9i1@t8FiS }F7_Àe BqbU-X&Ոe tM޸kp r29Dhhn)*_8#yԊRn <7YoxܹKR'`y9u-<=:kd"B[U|';~ udvg#Ȼ +ϒqNVn%[E0AZ\-zѿ*A_Qc[b_&\sy@3_wVb"Î+_OYO

英语翻译Heavy duty hydraulic jacks where inside cylinder diameter is 300mm ,stroke 1.2 meters and shaft diameter 200mm and face mounting - just like in your press.cylinder thickness should be more than 25mm and should stand pressure 4000 psi.I ne
英语翻译
Heavy duty hydraulic jacks where inside cylinder diameter is 300mm ,stroke 1.2 meters and shaft diameter 200mm and face mounting - just like in your press.cylinder thickness should be more than 25mm and should stand pressure 4000 psi.
I need 3 feeding inlets for back side and one for front side where all4 inlets for 1.5 inch hydraulic horses.
麻烦懂的朋友帮忙翻译一下; 由于积分就只有10分了,所以也就只能给这么多了.不过如果肯帮忙,那真的非常感谢;

英语翻译Heavy duty hydraulic jacks where inside cylinder diameter is 300mm ,stroke 1.2 meters and shaft diameter 200mm and face mounting - just like in your press.cylinder thickness should be more than 25mm and should stand pressure 4000 psi.I ne
缸内径为300mm,活塞杆直径为200mm,行程为1.2m的重型立式液压千斤顶,根据你需要的压力选用端面安装(法兰安装?).缸筒厚度应大于25mm,能承受4000psi 的压力.
我需要四个进给油口,三个在后端,一个在前端.这四个油口全部用1.5inch 的软管(horse是=hoses?)连接.

重型液压千斤顶的地方内缸直径是300毫米,中风1.2米和轴直径200毫米,面对越来越多-就像在您的气缸厚度应大于2 5毫米,并应根据立场的压力-4000防扩散安全倡议。
我需要3口为背面和一个前端的地方,all4口为1.5英寸液压马