作业帮汉译英该怎样翻一、所需工具：FLUKE 81 Ⅲ 型数字万用表,十字改锥（中）,一字改锥（中）,一字改锥（小)十字改锥（小）,锤子二、拆卸包装：1.用工具将设备外包装拆除,将设备按图正立至于
来源：学生作业帮助网 编辑：作业帮 时间：2024/11/29 22:56:50
汉译英该怎样翻一、所需工具：FLUKE 81 Ⅲ 型数字万用表,十字改锥（中）,一字改锥（中）,一字改锥（小)十字改锥（小）,锤子二、拆卸包装：1.用工具将设备外包装拆除,将设备按图正立至于
汉译英该怎样翻
一、所需工具：FLUKE 81 Ⅲ 型数字万用表,十字改锥（中）,
一字改锥（中）,一字改锥（小)
十字改锥（小）,锤子
二、拆卸包装：
1.用工具将设备外包装拆除,将设备按图正立至于地面
2.用一字改锥将设备两边侧门拆下.
3.拆除固定包装绳及泡沫.
4.将电源线插在设备底部滤波器上
5.用1平方接地线接在地线接线柱上,电源线和地线从设备底部穿入.
6.关上设备的侧门和后门.
7.将6mm的气管连在图中蓝色气管所在位置,调节气缸气压在0.6Mpa .
汉译英该怎样翻一、所需工具：FLUKE 81 Ⅲ 型数字万用表,十字改锥（中）,一字改锥（中）,一字改锥（小)十字改锥（小）,锤子二、拆卸包装：1.用工具将设备外包装拆除,将设备按图正立至于
参考下.不知道有没有错
First,the required tools:FLUKE 81 Ⅲ digital multimeter,Phillips screwdriver (medium),
Word screwdriver (medium),the word screwdriver (small)
Phillips screwdriver (small),hammer
Second,the demolition of packaging:
1.With the tool to remove the device packaging,the equipment was set As Figure ground
2.With the word screwdriver to remove the equipment both sides of the side door.
3.Removal of the fixed ropes and foam packaging.
4.The power cord plugged into the device on the bottom of the filter
5.With a square ground wire connected to the ground terminal,the power and ground penetration from the bottom of the device.
6.Close the side door and back door devices.
7.To 6mm with the trachea tube in the location shown in blue,adjust the cylinder pressure at 0.6Mpa